POWER TRIM - DESIGN II
Page 5B-40 90-884294 OCTOBER 2001
TRIM ROD INSTALLATION
IMPORTANT: Components must be free of dirt and lint. Any debris in the system
can cause system to malfunction.
NOTE: Install trim rod with check valve in the port (left) cylinder.
1. Apply ATF Dexron III or Power Trim and Steering Fluid on all O-rings and seals before
installation.
2. Install trim rods and caps. Use installation tool (91-44487A1) or spanner wrench
(91-74951) to tighten caps securely – 70 lb. ft. (95 N m ).
58450
a
a
b
c
a-Trim Rods
b-Cylinder End Caps
c-Rod End Rollers (lubricate with Anti-Corrosion Grease or
Special Lubricant 101)
To Next Page
Loading...
