POWER TRIM - DESIGN II
90-884294 OCTOBER 2001 Page 5B-43
2. Clamp tilt rod in a soft jawed vise. Remove bolt or nut as applicable to disassemble
rod assembly. Remove O-ring.
51378
51340
a
b
a
b
a-Stud/Nut
b-O-Ring
IMPORTANT: Design 1 tilt rod assembly can be used to replace a Design 2 tilt rod
assembly. Design 1 or Design 2 cylinder assemblies (complete) can be used as re-
placements.
Design 2 will NOT fit a cylinder originally using a Design 1 tilt rod assembly.
Memory Pistons for Design 1 and 2 differ also and must be used only on the cylin-
der the piston was removed from.
3. Remove washer, check valve assemblies, and piston.
NOTE: Check valve held in by roll pin can be cleaned but not removed.
51363
b
a
c
a
b
c
a-Washer
b-Check Valve Assembly (7)
c-Piston
To Next Page
Loading...
