POWER TRIM - DESIGN II
Page 5B-46 90-884294 OCTOBER 2001
REASSEMBLY
IMPORTANT: Components must be clean for reassembly. Any debris in the system
can cause the system to malfunction.
NOTE: Refer to “Tilt Ram Components” for proper O-ring sizes.
1. Apply ATF Dexron III or Power Trim and Steering Fluid on O-rings prior to reassembly.
2. Install O-ring on Memory Piston Cup and install in cylinder.
3. Inspect and replace as required 3 O-rings in the bottom of the tilt cylinder.
4. Inspect and replace as required 3 pivot pin O-rings in the manifold.
58462
a
b
a-O-ring
b-Memory Piston Cup
5. Assemble end cap.
6. Install end cap.
51376
c
b
a
b
a
b
b
c
d
a-End Cap
b-O-ring (2)
c-Scraper seal
d-End Cap
To Next Page
Loading...
