POWER TRIM - DESIGN II
Page 5B-48 90-884294 OCTOBER 2001
TILT RAM ASSEMBLY INSTALLATION
1. Lubricate alignment tool (91-11230) and shaft. Use ATF Dexron III or Power Trim and
Steering Fluid.
a
b
a-Alignment Tool (91-11230)
b-Shaft
2. Align tilt ram and housing using alignment tool.
3. Install shaft.
51348
a
a
58603
d
c
a
b
a-Alignment Tool (91-11230)
b-Shaft
c-Groove
d-Hole [Groove (c) will Align with this
Hole]
4. Drive pin in until flush.
51356
a
a
a-Pin (Drive Against Knurled End)
To Next Page
Loading...
