RIGHT HAND NON-RATCHETING
90-884294 OCTOBER 2001 Page 6A-19
2. Remove the bearing carrier retainer following step a or b as follows:
CAUTION
DO NOT drill into the gear housing retainer threads when using the following pro-
cedure for removing the retainer
a. If the retainer is corroded in place, drill 4 holes in the retainer and fracture the re-
tainer with a chisel. Pry the remaining segments out.
23356
a
a-Drilled Holes
b. Remove the bearing carrier retainer using the Bearing Carrier Retainer Wrench
(91-61069).
a
70491
a-Bearing Carrier Retainer Wrench
To Next Page
Loading...
