RIGHT HAND NON-RATCHETING
Page 6A-22 90-884294 OCTOBER 2001
IMPORTANT: The bearing MUST BE replaced if removed from gear.
5. Place the universal puller plate between the thrust washer and bearing as shown and
press on the plate until it bottoms.
23351
a
b
c
a-Universal Puller Plate (91-37241)
b-Thrust Washer
c-Bearing
6. Using a suitable mandrel and the universal puller plate to support the bearing, press
the bearing from the reverse gear as shown.
a
b
c
d
23351
a-Universal Puller Plate
(91-37241)
b-Bearing
c-Gear
d-Mandrel
a. Discard the bearing.
b. Inspect the gear, and thrust washer for excessive wear, cracks, or damage. Re-
place the appropriate components if any of these conditions are found.
To Next Page
Loading...
