RIGHT HAND NON-RATCHETING
90-884294 OCTOBER 2001 Page 6A-37
3. If inspection determines that replacement of propeller shaft needle bearings is re-
quired, remove bearing as follows:
a. Clamp forward gear in a soft jaw vise securely.
b. Use suitable tools (screwdriver and awl) to remove retaining ring. Use a punch
and hammer to remove bearing.
57905
a
b
19203
a-Retaining RIng
b-Bearing
FORWARD GEAR ASSEMBLY - Component Reassembly
NOTE: Complete the instructions in this section only if the assembly components have
been disassembled and repaired or replaced.
1. Apply Premium Gear Lubricant to I.D. of forward gear. Press bearing into forward gear
using Forward Gear Bearing Installer Tool until tool contacts gear.
a
b
Premium Gear Lubricant
87
87
91-877321A1
a-Forward Gear Bearing Installer (91-877321A1)
b-Needle Bearing, Numbered Side Toward Installer Tool
To Next Page
Loading...
