LEFT HAND NON-RATCHETING
Page 6B-14 90-884294 OCTOBER 2001
7. While pressing in on speedometer hose junction, pull out on hose to disconnect.
57735
a
b
a-Press in on Junction
b-Pull out on Hose
8. Loosen the side mounting locknuts. (DO NOT attempt to remove one nut before oppo-
site side is loosened sufficiently, or gear housing could be damaged.)
a
a-Side Mounting Locknuts
9. Pull gear housing away from drive shaft housing as far as the loosened nuts (in Step
8) will allow, then remove loosened nuts. (DO NOT allow gear housing to fall, as it now
is free.)
10. Pull gear housing from drive shaft housing.
To Next Page
Loading...
