LEFT HAND NON-RATCHETING
90-884294 OCTOBER 2001 Page 6B-23
3. Pull the bearing carrier from the gear housing by pulling on the outer ring of the bearing
carrier. POSITION PULLER JAWS CLOSE TO BOSSES IN CARRIER.
NOTE: If the bearing carrier is seized in the gear housing, it may be necessary to use heat
to loosen the carrier.
50786
b
a
a-Puller Jaws (91-46086A1)
b-Puller Bolt (91-85716)
4. Lift the bearing carrier out of the gear housing. Locate and retain the thrust washer
that may be stuck to the inside surface of the bearing carrier.
50826
50779
a
a
a-Thrust Washer
To Next Page
Loading...
