LEFT HAND NON-RATCHETING
Page 6B-26 90-884294 OCTOBER 2001
9. Remove the forward thrust bearing.
a
50783
a-Thrust Bearing
10. Form a tool using a 1/8 in. (3 mm) wire as shown in the following figure and remove
the forward gear bearing adaptor.
50786
a
b
a-Wire Tool
b-Forward Gear Bearing Adaptor
11. Shift gear case into forward gear.
NOTE: The thrust race has a tight fit in the gear housing bore. Use the Forward Gear In-
stallation Tool (91-815850) to remove the thrust race and the forward gear together. If this
attempt fails, form a small hook on the end of a stiff piece of wire and while applying heat
to the outside of gear case, pull the thrust race up and out of the gear housing.
To Next Page
Loading...
