LEFT HAND NON-RATCHETING
Page 6B-34 90-884294 OCTOBER 2001
FORWARD GEAR BEARING ADAPTOR ASSEMBLY - COMPONENT DISASSEMBLY AND
REASSEMBLY
NOTE: Complete the instructions in this section only if the needle bearing in the bearing
adaptor is defective and the adaptor is to be reused.
1. Disassemble the adaptor as follows:
a. Remove the bearing from the adaptor using the bearing removal tool. Align the
pins of the tool with the holes of the adaptor and apply pressure to the center of
the tool so that the pressure is equal on both of the pins. Discard the bearing.
50874
b
a
c
c
d
a-Forward Gear Bearing Adaptor
b-Bearing Removal Tool (91-816245)
c-Pins
d-Universal Puller Plate
2. Assemble the adaptor as follows:
a. Lubricate the bore that the needle bearing is pressed into with 2-4-C Marine Lubri-
cant with Teflon.
b. Assemble the needle bearing to the adaptor with the numbered end of the bearing
facing the driver shoulder.
c. Press the needle bearing into the bearing adaptor using a suitable mandrel until
the bearing bottoms in the adaptor.
To Next Page
Loading...
