Mercury 225 EFI - Page 615

LEFT HAND NON-RATCHETING
90-884294 OCTOBER 2001 Page 6B-51
REVERSE GEAR BEARING ADAPTOR ASSEMBLY - COMPONENT DISASSEMBLY AND
REASSEMBLY
NOTE: Complete the instructions in this section only if the needle bearing in the bearing
adaptor is defective and the adaptor is to be reused.
1. Disassemble the adaptor as follows:
a. Remove the bearing from the adaptor using a suitable mandrel.
b. Discard the bearing.
2. Assemble the adaptor as follows:
a. Lubricate the bore that the needle bearing is to be pressed into with 2-4-C Marine
Lubricant with Teflon.
b. Position the needle bearing on the adaptor with the numbered end of the bearing
facing the driver shoulder.
c. Press the needle bearing into the bearing adaptor using a suitable mandrel until
the bearing is flush with the face of the adaptor.
50790
95
c
b
a
95
2-4-C Marine Lubricant With Teflon
a-Reverse Gear Bearing Adaptor
b-Suitable Mandrel
c-Bearing