LEFT HAND NON-RATCHETING
90-884294 OCTOBER 2001 Page 6B-53
SHIFT SHAFT ASSEMBLY - Component Disassembly and Inspection
1. Slide the bushing assembly off the shift shaft. Remove the coupler from the shaft.
57954
c
b
a
e
d
a-Shift Shaft Bushing Assembly
b-O-ring
c-Shift Shaft
d-Gasket
e-Rubber Washer
2. Clean all components with a suitable solvent and dry thoroughly with compressed air.
a. Inspect the shift shaft bushing for cracking, damage, or excessive wear.
b. Inspect the oil seal inside the bushing, the sleeve, and the O-rings on the outside
of the bushing for damage or excessive wear.
c. Inspect the speedometer connector for damage or blockage.
If any of these conditions exist, replace the appropriate components.
57932
a
b
c
a-Shift Shaft Bushing
b-Oil Seal (Oil Seal is Replaceable)
c-Speedometer Tube Connector
To Next Page
Loading...
