LEFT HAND NON-RATCHETING
90-884294 OCTOBER 2001 Page 6B-81
4. Assemble the cross pin through the sliding clutch, through the propeller shaft and
through the shift spool shaft hole.
5. Install detent pin in third hole in clutch.
58012
c
d
e
b
a
f
a-Propeller Shaft
b-Sliding Clutch
c-Cross Pin
d-Reverse Gear
e-Shift Spool Assembly
f-Detent Pin
6. Assemble the cross pin retaining spring over the propeller shaft and wind it around
the clutch over the cross pin hole. Be careful not to distort the spring while assembling
it. Make sure that the spring is wound on so that it does not cross over on itself
and that it lies flat against the clutch once it is assembled. If it does not lie flat
against the clutch a new spring must be installed.
58015
c
b
a
a-Sliding Clutch
b-Propeller Shaft
c-Cross Pin Retaining Spring
To Next Page
Loading...
