ATTACHMENTS / CONTROL LINKAGE
Page 7-12 90-884294 OCTOBER 2001
Install steering cable mounting tube into mounting bracket with 2 adjusting nuts and 2
locking tab washers. Be sure longer threaded end of tube is toward starboard side of boat.
Temporarily adjust tube, so that longer threaded end of tube extends out the same dis-
tance as the outboard tilt tube. Do not tighten adjustment nuts at this time.
51891
a
b
c
d
a-Steering Cable Mounting Tube (End of Tube with Longer Threads Toward
Starboard Side of Boat)
b-Mounting Bracket
c-Locking Tab Washers (2)
d-Adjustment Nuts (Flats of Nuts Facing Toward Locking Tab Washer)
IMPORTANT: Lubricate inside of steering cable mounting tube with 2-4-C Marine
Lubricant with Teflon before installing steering cable.
Lubricate inside of steering cable mounting tube (starboard outboard) with 2-4-C Marine
Lubricant with Teflon.
Insert steering cable end through cable mounting tube and thread steering cable attach-
ing nut onto tube hand tight.
NOTE: Torque steering cable attaching nut only after final steering adjustments have
been made.
51887
a
b
c
a-Steering Cable End
b-Cable Mounting Tube
c-Steering Cable Attaching Nut
To Next Page
Loading...
