ATTACHMENTS / CONTROL LINKAGE
90-884294 OCTOBER 2001 Page 7-19
Temporarily adjust tube, so that longer threaded end of tube extends out the same dis-
tance as the outboard tilt tube. Do not tighten adjustment nuts at this time.
51891
a
c
b
d
a-Steering Cable Mounting Tube (End of Tube with Longer Threads Toward
Center of Boat Transom)
b-Mounting Bracket
c-Locking Tab Washers (2)
d-Adjustment Nuts (Flats of Nuts Facing Toward Locking Tab Washer)
IMPORTANT: Lubricate inside of steering mounting tube with 2-4-C Marine Lubri-
cant with Teflon before installing steering cable.
Lubricate inside of steering cable mounting tube (starboard outboard) with 2-4-C Marine
Lubricant with Teflon.
Insert steering cable end (a) (steering cable routed down port side of boat) through cable
mounting tube (b) and thread steering cable attaching nut (c) onto tube hand tight.
NOTE: Torque steering cable attaching nut only after final steering adjustments have
been made.
51887
a
b
c
Place a mark (a) on steering cable mounting tube (b) 5/8 in (16 mm) from end of mounting
tube. Slide plastic spacer (c), O-ring (d) and cap (e) over steering cable.
5/8″(16 mm)
51890
a
b
c
d
e
To Next Page
Loading...
