6-30 MINI Hawk High Performance Imager User’s Manual
Postal Symbologies
Postal Symbology Type
Usage: The following 1D Postal Symbologies are used in mail sortation, auditing,
certified mail, registered mail, metered mail, and point-of-sale (POS) applications.
Definition: Determines the postal symbology that will be decoded by the imager.
Postal symbology decode performance depends on accurate sampling
density information. Sampling density is determined by measuring the width
in pixels of a symbol image and then dividing that value by the width of the
actual symbol in inches or meters. For example, an image of a one-inch-wide
symbol that is 200 pixels across would have a sampling density of 200 dots
per inch.
The following table shows the range of supported sampling densities.
Symbology
Minimum
Sample
Density
Maximum
Sample
Density
Unit of
Measurement
U.S. Post
(POSTNET, PLANET,
USPS4CB)
80 310 dots per inch
3150 12205 dots per meter
Australia Post
86 332 dots per inch
3386 13071 dots per meter
Japan Post
84 324 dots per inch
3307 12756 dots per meter
Royal Mail, KIX
82 317 dots per inch
3228 12489 dots per meter
UPU
80 310 dots per inch
3150 12205 dots per meter
Serial Cmd:
<
K460,postal symbology type
,POSTNET status,PLANET status,USPS4CB
status,POSTNET allow B and B’ fields,Australia Post allow 0 FCC>
Default: Disabled
Options: 0 = Disabled
1 = U.S. Post (POSTNET, PLANET, USPS4CB)
2 = Australia Post
3 = Japan Post
4 = Royal Mail
5 = KIX
6 = UPU
To Next Page
Loading...
