MINI Hawk High Performance Imager User’s Manual iii
Introduction
Table of Contents
Chapter 1 Quick Start
Step 1 Check Required Hardware........................................................... 1-2
Step 2 Connect the System.....................................................................1-3
Step 3 Position Imager and Symbol ........................................................ 1-4
Step 4 Install ESP.................................................................................... 1-5
Step 5 Select Model ................................................................................ 1-6
Step 6 Select Protocol and Connect........................................................1-7
Step 7 Locate the Symbol in the Field of View ........................................ 1-9
Step 8 Calibrate.....................................................................................1-11
Step 9 Test Read Rate .......................................................................... 1-12
Step 10 Configure the Imager in ESP ................................................... 1-13
Step 11 Save Configuration in ESP....................................................... 1-14
Chapter 2 Using ESP
EZ Mode .................................................................................................. 2-2
Application Mode ..................................................................................... 2-3
Menu Toolbar ..........................................................................................2-4
Autoconnect.......................................................................................... 2-12
View...................................................................................................... 2-14
Navigating in ESP................................................................................. 2-15
Send/Receive Options.......................................................................... 2-16
Using EZ Trax........................................................................................2-18
Chapter 3 Communications
Communications by ESP......................................................................... 3-2
Communications Serial Commands ........................................................ 3-3
Host Port Connections.............................................................................3-4
Host Port Protocol ................................................................................... 3-5
ACK/NAK Options ................................................................................... 3-7
Polling Mode Options .............................................................................. 3-8
RS-422 Status ......................................................................................... 3-9
Auxiliary Port Connections ....................................................................3-10
Auxiliary Port System Data Status......................................................... 3-18
Daisy Chain Autoconfigure ....................................................................3-19
Response Timeout ................................................................................ 3-20
LRC Status ............................................................................................3-21
Protocol Configuration Examples .......................................................... 3-22
USB HID Interface ................................................................................. 3-23
ASCII Character Entry Modifier ............................................................. 3-32
Preamble ............................................................................................... 3-33
Postamble.............................................................................................. 3-34
Chapter 4 Calibration
Calibration Serial Commands.................................................................. 4-2
To Next Page
Loading...
