MINI Hawk High Performance Imager User’s Manual 10-19
Camera and IP Setup
Focal Distance Table (Read-Only)
Number of Focal Distances
Focal Distance
Definition: Specifies the number of focal distances supported by the imager.
Serial Cmd: <K526,number of focal distances,focal distance>
Options: 1 to 255
Definition: Each (x) output represents a focal distance that is supported by the
imager. The values are specified in 1/100ths of an inch, but the focal
distance increments and decrements are not that fine. The focal distance
is defined from a curve equation whose constants are calibrated during
factory setup. The output value is in terms of inches, and it is multiplied
by 100 to remove the decimal place. For example, an output of 375
would signify a focal distance of 3.75”.
Serial Cmd: <K526,number of focal distances,focal distance>
Options: 200 (2”) to 600 (6”)
To Next Page
Loading...
