Microscan MINI Hawk - Request All Configuration Database Settings

372 pages

Save Page as PDF

To Next Page

To Previous Page

11-18 MINI Hawk High Performance Imager User’s Manual

Request All Configuration Database Settings

Example:

<K255?>

This command phrase returns the configuration settings for all 10 database indexes.

Definition: Returns configuration settings for all indexes in the Configuration Database.

Serial Cmd: <K255?>

Main Page

Default Chapter2
- Technical Support2
- Table of Contents3
- Statement of Agency Compliance10
Chapter 1 Quick Start13
Step 1 Check Required Hardware14
Step 2 Connect the System15
Step 3 Position Imager and Symbol16
Step 4 Install ESP17
Step 5 Select Model18
Step 6 Select Protocol and Connect19
Step 7 Locate the Symbol in the Field of View21
Step 8 Calibrate23
Step 9 Test Read Rate24
Step 10 Configure the Imager in ESP25
Step 11 Save Configuration in ESP26
- Using Esp27
EZ Mode28
Application Mode29
Menu Toolbar30
Autoconnect38
View40
Navigating in ESP41
Send/Receive Options42
Using EZ Trax44
- Communications45
Communications by ESP46
Communications Serial Commands47
Host Port Connections48
Host Port Protocol49
Poll Address50
ACK/NAK Options51
Polling Mode Options52
RS-422 Status53
Auxiliary Port Connections54
- Transparent Mode56
- Half Duplex Mode57
- Full Duplex Mode58
- Daisy Chain Mode59
- Command Processing Mode60
- Daisy Chain ID Status61
Auxiliary Port System Data Status62
Daisy Chain Autoconfigure63
Response Timeout64
LRC Status65
Protocol Configuration Examples66
USB HID Interface67
ASCII Character Entry Modifier76
Preamble77
Postamble78
- Calibration79
Calibration Overview80
Calibration Serial Commands80
Calibration Options81
Calibration by ESP89
Initiating Calibration91
Additional Notes about Calibration97
- Read Cycle99
Read Cycle by ESP100
Read Cycle Serial Commands101
Read Cycle Setup102
Multisymbol103
Trigger Mode and Filter Duration104
- Continuous Read 1 Output105
- Serial Data107
External Trigger Polarity109
Serial Trigger110
Start Trigger Character (Non-Delimited)111
Stop Trigger Character (Non-Delimited)112
End of Read Cycle113
Read Cycle Timeout114
Capture Mode115
- Timed Capture117
- Triggered Capture118
Capture Timing119
Image Processing Timeout121
Image Storage122
Image Storage123
Minimum Good Reads124
Setting up the Imager for EZ Trax125
- Symbologies127
Symbologies by ESP128
Symbologies Serial Commands129
Data Matrix130
Aztec Code132
QR Code133
Micro QR Code134
Code 39135
Code 128/EAN 128138
Bc412141
Interleaved 2 of 5142
Code 93145
- Codabar146
Upc/Ean149
Pharmacode153
Postal Symbologies155
Australia Post157
GS1 Databar (RSS)160
Pdf417162
Micropdf417163
Composite164
Narrow Margins/Symbology ID165
- Narrow Margins/Symbology Identifier165
Background Color167
Background Color168
Chapter 7 I/O Parameters170
- I/O Parameters by ESP170
- I/O Parameters Serial Commands171
- Symbol Data Output172
- When to Output Symbol Data174
- No Read Message175
- Read Duration Output176
- Output Indicators177
- Green Flash Duration180
- Beeper181
- LED Configuration182
- Serial Verification183
- EZ Button185
- EZ Button Modes187
  - Bar Code Configuration188
  - Ez Button Operation188
- Configurable Output 1189
- Configurable Output 1190
  - Symbol Quality190
  - Output Mode191
- Trend Analysis Output 1192
  - Trend Analysis Mode193
  - Trigger Evaluation Period194
- ISO/IEC 16022 Symbol Quality Output 1195
  - Output on Symbol Contrast195
  - Output on Print Growth195
  - Symbol Contrast Threshold196
  - Print Growth Threshold197
- Diagnostic Output 1198
- Service Unit198
- Configurable Output 2199
- Trend Analysis Output 2199
- ISO/IEC 16022 Symbol Quality Output 2199
- Diagnostic Output 2199
- Configurable Output 3200
- Trend Analysis Output 3200
- Diagnostic Output 3200
- ISO/IEC 16022 Symbol Quality Output 1200
- Configurable Output 2200
- Power-On/Reset Counts201
- Time Since Reset202
- Service Message203
- Frame Information204
- Image Output205
- Communication Port206
- Database Identifier Output208
- Quality Output209
- Configuring EZ Trax Output210
  - Image Mode211
  - Image Format211
- Symbol Quality by ESP218
Chapter 8 Symbol Quality219
- Symbol Quality Serial Commands219
- Overview of Symbol Quality220
- Symbol Quality by ESP224
- Symbol Quality Separator/Data Matrix Output Mode224
- ISO/IEC 16022 Symbol Quality Output226
- Print Growth226
- ISO/IEC 16022 Symbol Quality Output by ESP228
- Microscan Symbol Quality Output229
- Decode Time230
- Microscan Symbol Quality Output by ESP232
Chapter 9 Matchcode by ESP234
- Matchcode Serial Commands235
- Overview of Matchcode236
- Matchcode Type237
- Match Replace242
- Mismatch Replace243
- New Master Pin244
Camera and Ip Setup245
Chapter 10 Camera and IP Setup246
- Camera and IP Setup by ESP246
- Camera and IP Setup Serial Commands247
- Video248
- Evaluation249
- Line Scan251
Chapter 4 Calibration252
- Window of Interest253
- Configuration Database256
- Dynamic Setup257
  - X-Mode258
- Pixel Sub-Sampling259
- Camera Settings261
- Focal Distance262
- Focal Distance Table (Read-Only)263
- Increment Focus Position264
- Decrement Focus Position264
- Mirrored Image265
- Illumination Brightness266
- Skew Correction267
  - Morphological Pre-Processing270
  - Morphological Operation and Operator Size271
Chapter 11 Configuration Database276
- Configuration Database Serial Commands276
- Number of Active Indexes277
- Configuration Database Status278
- Database Mode284
- Save Current Settings to Configuration Database289
- Load Current Settings from Configuration Database290
- Request Selected Index Settings291
- Request All Configuration Database Settings292
Chapter 12 Terminal294
- Terminal Window294
- Find295
- Send296
- Macros297
- Editing a Macro297
- Terminal Window Menus298
- Output Format323
- Appendices337
Appendix A General Specifications338
- Communication Protocols338
Appendix B Electrical Specifications341
Appendix C Serial Configuration Commands344
Chapter 3 Appendix D Communications Protocol350
Appendix E ASCII Table359
Appendix F Interface Standards360
Appendix G Using an External Trigger361
Appendix G Object Detector362
Appendix H Operational Tips362
Appendix I USB-To-Serial Virtual COM Port Driver363
Appendix J Glossary of Terms366

Microscan MINI Hawk - Request All Configuration Database Settings

Table of Contents

Other manuals for Microscan MINI Hawk

Related product manuals