Microscan MINI Hawk - Protocol Configuration Examples

3-22 MINI Hawk High Performance Imager User’s Manual
Protocol Configuration Examples
Protocol Configuration Examples
Point-to-Point (Main Port)
Polling Mode (Main Port)
“User-Defined” Polling Mode (Main Port)
ACK/NAK (Main Port)
Auxiliary Port
Listed below are several examples of Auxiliary Port commands.
<K100,8,0,1,1> Baud Rate: 115.2K; Parity: None; Stop Bits: 2; Data Bits: 8
<K140,0> Point-to-Point
<K102,0> RS-232 enabled; <K102,1> = RS-422 enabled
<K100,4,0,1,1> Baud Rate: 9600; Parity: None; Stop Bits: 2; Data Bits: 8
<K140,5,23> Polling Mode; Address: 23
<K102,0>
RS-232 Point-to-Point polling; <K102,1> = RS-422/RS-485 true multidrop
(switched transmitter)
<K143,30> 30 ms Response Timeout
<K100,4,0,1,1> Baud Rate: 9600; Parity: None; Stop Bits: 2; Data Bits: 8
<K140,5,12> Polling Mode; Address: 12
<K148,,08,09,18,0B,0C,0D> Default RES (0x04), REQ=0x08; EOT=0x09; STX=0x18;
ETX=0x0B; ACK=0x0C; NAK=0x0D
<K102,0> RS-232 Point-to-Point polling; <K102,1> = RS-485 (true
multidrop with switched transmitter)
<K143,40> 40 ms Response Timeout
<K100,9,0,1,1> Baud Rate: 230K; Parity: None; Stop Bits: 2; Data Bits: 8
<K140,4> ACK/NAK
<K147,,,01,1B,2E,1F> Default RES and REQ (00, disabled); STX=0x01; ETX=0x1B;
ACK=0x2E; NAK=0x1F
<K102,1> RS-422 enabled; <K102,0> = RS-232 enabled
<K143,50> 50 ms Response Timeout
<K101,2,4,0,1,1> Half Duplex; Baud Rate: 9600; Parity: None; Stop Bits: 2; Data Bits: 8
<K101,1,5,0,1,1> Transparent; Baud Rate: 19.2K; Parity: None; Stop Bits: 2; Data Bits: 8
<K101,3,7,0,1,1> Full Duplex; Baud Rate: 57.6K; Parity: None; Stop Bits: 2; Data Bits: 8
<K101,5,6,0,1,1> Command Processing; Baud Rate: 230K; Parity: None; Stop Bits: 2;
Data Bits: 8