Microscan MINI Hawk - Utilities

MINI Hawk High Performance Imager User’s Manual 13-1
13 Utilities
Contents
Utility commands are generally commands that are performed during imager operations to
check or determine read rates, or to perform miscellaneous operations on imager hardware.
Serial utility commands are not prefaced with a “
K ” and a numeric code, nor do they require an
initialization command (
<A> and <Z> ). They can be entered from within any terminal program
or from
ESP ’s Terminal or Utilities windows.
Serial Utility Commands ............................................................................................................. 13-2
Read Rate .................................................................................................................................. 13-4
Counters..................................................................................................................................... 13-5
Device Control............................................................................................................................ 13-7
Differences from Default............................................................................................................. 13-8
Master Database ........................................................................................................................ 13-9
Firmware................................................................................................................................... 13-15
Default/Reset/Save................................................................................................................... 13-18
Imager Status Requests........................................................................................................... 13-20
Other Operational Serial Commands ....................................................................................... 13-22