10-1
10 Monitoring Temp
10.1 Introduction
You can simultaneously monitor two temperature sites using the MPM. The monitor can
automatically identify the temperature probe type.
10.2 Safety
WARNING
z Verify that the probe detection program works correctly before monitoring. Plug
out the temperature probe cable from the T1 or T2 connector, and the monitor can
display the message [T1 Sensor Off] or [T2 Sensor Off] and give alarm tones
correctly.
z The temperature measurement functioning should be calibrated every two years,
or as indicated by your standard hospital procedure.
Connector for
Temp probe 1
Connector for
Temp probe 2
To Next Page
Loading...
