Mindray BeneView T8 - Alarm Tone Configuration; Changing the Alarm Volume; Switching the Alarm Sound On;Off; Setting the Interval between Alarm Sounds

Alarms
6-5
6.4 Alarm Tone Configuration
6.4.1 Changing the Alarm Volume
1. Select the [Alarm Setup] QuickKey, or [Main Menu]→[Alarm Setup >>].
2. Select [Alarm Volume] and then select the appropriate volume. 1 is minimum volume,
and 10 the maximum volume.
6.4.2 Switching the Alarm Sound On/Off
1. Select [Main Menu]→[Maintenance >>]→[User Maintenance >>]→enter the
required password.
2. Select [Alarm Setup >>] to enter the [Alarm Setup] menu.
3. Select [Alarm Sound] and toggle between [On] and [Off].
6.4.3 Setting the Interval between Alarm Sounds
1. Select [Main Menu]→[Maintenance >>]→[User Maintenance >>]→enter the
required password.
2. Select [Alarm Setup >>] to enter the [Alarm Setup] menu.
3. Select [High Alarm Interval (s)], [Med Alarm Interval (s)] and [Low Alarm Interval
(s)] in turn and then select the appropriate settings.
WARNING
z When the alarm sound is switched off, the patient monitor will give no audible
alarm tones even if a new alarm occurs. Therefore the user should be very careful
about whether to switch off the alarm sound or not.
z Do not rely exclusively on the audible alarm system for patient monitoring.
Adjustment of alarm volume to a low level may result in a hazard to the patient.
Always keep the patient under close surveillance.