Mindray BeneView T8 - Editing Patient Information; Discharging a Patient

Managing Patients
4-3
4.3 Editing Patient Information
To edit the patient information after a patient has been admitted, or when the patient
information is incomplete, or when you want to change the patient information:
1. Select the [Patient Setup] QuickKey, or [Main Menu]→[Patient Setup >>].
2. Select [Patient Demographics] and then make the required changes.
3. Select [Ok].
4.4 Discharging a Patient
To discharge a patient:
1. Select the [Patient Setup] QuickKey, or [Main Menu]→[Patient Setup >>].
2. Select [Discharge Patient]. In the popup menu, you can either:
 Directly select [Ok] to discharge the current patient, or
 Select [Standby] then [Ok]. The patient monitor enters the standby mode after
discharging the current patient, or
 Select [Cancel] to exit without discharging the patient.