Mindray BeneView T8 Operation Manual

The Basics
2-3
3. Display Screen
4. Power On/Off Switch
Press this switch to turn the patient monitor on. Press it again and hold for 2 seconds to
turn the patient monitor off. An indicator is built in this switch. It turns on when the
patient monitor is on and turns off when the patient monitor is off.
5. AC power LED
It turns on when AC power is connected.
6. Battery LED
 On: when the battery is being charged or already fully charged.
 Off: when no battery is installed or no AC source is connected.
 Flash: when the patient monitor operates on battery power.
7.
Press to silence all system sounds.
8.
Press to pause, restore or clear alarms.
9.
Press to freeze or unfreeze waveforms.
10.
Press to start or stop recordings.
11.
Press to start or stop NIBP measurements.
12.
If no menu is displayed on the screen, pressing it will enter the main menu.
If there is a menu displayed on the screen, pressing it will close that menu.
13. Knob
As shown in the figure, you can:
 Rotate the knob clockwise or anti-clockwise. With each click, the highlight jumps
to the neighboring screen item, or
 When you reach the desired screen item, press the knob to select the item.

Mindray BeneView T8 Specifications

General

Brand	Mindray
Model	BeneView T8
Category	Monitor
Language	English