3-6 System Preparation
1. Connect the data cable with the USB port on the system.
2. Plug the other end power plug into an appropriate outlet.
3. Power on the system and the printer.
4. Install the printer driver (drivers of printers listed in “2.5.4 Peripherals Supported” have
already installed):
(1) Enter [Setup]-> [Print Preset].
Enter “Printer Driver” page and the printers that are installed automatically will be
displayed in the list with the “Status” of “Ready”.
(2) Return to “Print Service” page, and select printer from the “Printer” list.
To Next Page
Loading...
