5
5.5 Selecting the Paper Source
5-24 Di1611/Di2011
Before Making Copies Chapter 5
To load special paper into the 1st Tray
If special paper, such as OHP transparencies, postcards or cards are loaded into
the 1st Tray, first set the “TRAY1 PAPER” function in the “PAPER SOURCE
SETUP” menu of the Utility mode (“To specify the size of paper loaded into the 1st
Tray (“TRAY1 PAPER” function)” on page 7-19).
Depending on the paper type set for the “TRAY1 PAPER” function, the screen
changes as shown below.
Cards OHP transparencies
Postcards or envelopes
To Next Page
Loading...
