Minolta Di1611 - To Specify the Erased Width (ERASE SETTING Function)

7.6 Specifying Copy Settings
7
Di1611/Di2011 7-47
Utility Mode – Copy Functions Chapter 7
To specify the erased width (“ERASE SETTING” function)
1 Select the “COPY SETTING 1” menu.
❍ Refer to “To select the “COPY
SETTING 1” menu” on page 7-40.
2 Press the [7] key from the 10-Key Pad
to select “ERASE SETTING”.
3 Using the and keys, select
“LEFT”, “UPPER” or “FRAME”, and
then press the [Yes] key.
4 Using the 10-Key Pad, enter the width
of the area to be erased, and then
press the [Yes] key.
❍ The width of the area to be erased
can be set between 5 mm and 20
mm.
❍ If you wish to correct the setting, press the [No] key, and then enter the new
number.
The “COPY SETTING 1” menu appears again.