5
5.4 Making Copies on Manually Fed Paper
5-16 Di1611/Di2011
Before Making Copies Chapter 5
Copying Onto Manually Fed Paper
To copy using the Manual Bypass
1 Load the document to be copied.
❍ Refer to “Loading the Document” on page 3-9.
2 Adjust the paper guides to fit the size
of the paper.
3 Insert one sheet of paper with the front
side facing down, lightly sliding the
paper as much as possible into the
feed slot.
The manual bypass mark ( )
appears in the bottom line of the
screen.
?
Is a card or a postcard loaded?
➜ Make sure that it is not curled
(rolled).
4 Press the [No] key.
The “PAPER SOURCE SETUP” menu appears.
5 Use the and keys to select
the type of paper loaded.
❍ Select from the following four
paper type settings.
“PLAIN”
“OHP”
“CARD”
“ENVELOPE”
6 Press the [Yes] key.
The “PAPER SIZE” menu appears.
To Next Page
Loading...
