Minolta Di1611 - Specifying Copy Settings; COPY SETTING 1 & COPY SETTING 2 Menus

7
7.6 Specifying Copy Settings
7-38 Di1611/Di2011
Utility Mode – Copy Functions Chapter 7
7.6 Specifying Copy Settings
“COPY SETTING 1” & “COPY SETTING 2” menus
The settings that are automatically selected when the machine is turned off or the
[Panel Reset] key is pressed are called the “default settings”. From the “COPY
SETTING 1” menu, the default settings for various functions can be specified.
“COPY SETTING 1” menu:
No. COPY SETTING 1 Description
1 PAPER PRIORITY This function can be used to specify the tray that should be
given priority when the “AUTO” Zoom setting is selected.
• The manufacturer’s default setting is “1ST”.
2 DENSITY PRIORITY This function can be used to set the density to “TEXT”,
“PHOTO” or “TEXT/P” when the machine is turned off or the
[Panel Reset] key is pressed.
• The manufacturer’s default setting is “TEXT/P”.
3 DENSITY LEVEL(A) This function can be used to set the density level of the “AUTO”
Density setting to one of the three settings between “LIGHT”
and “DARK”.
• The manufacturer’s default setting is the middle level
().
4 DENSITY LEVEL(M) This function can be used to set the density level of the manual
density setting to one of the nine settings between “LIGHT” and
“DARK”.
• The manufacturer’s default setting is the middle level
().
5 BINDING POS. This function can be used to set whether the first page of a book
to be scanned is on the left (left-bound) or on the right (right-
bound).
• The manufacturer’s default setting is “LEFT”.
6 MARGIN SETTING This function can be used to specify the width of the binding
area (margin) between 0 mm and 20 mm (in units of 1 mm)
when copying documents to be bound.
• The manufacturer’s default setting is 10 mm.
7 ERASE SETTING This function can be used to specify between 5 mm and 20 mm
(in units of 1 mm) the width that is erased when making copies
with the “Erase” function set to “LEFT”, “UPPER” or “FRAME”.
• The manufacturer’s default setting for the “LEFT”, “UPPER”
and “FRAME” Erase settings is 10 mm.
8 SMALL ORIGINAL This function is used to specify whether or not copying is
possible after loading a small document whose size cannot be
automatically detected.
• The manufacturer’s default setting is “ENABLE”.