5
5.5 Selecting the Paper Source
5-26 Di1611/Di2011
Before Making Copies Chapter 5
Order for Automatically Switching Paper Drawers
When a different paper drawer is automatically selected, the next paper drawer in
the following list is chosen.
1st paper drawer → 2nd paper drawer → 3rd paper drawer → 4th paper drawer
→ 5th paper drawer → Multiple Bypass
✎
Note
If special media, such as OHP transparencies or label sheets, are loaded into
the 1st paper drawer or the Multiple Bypass, the auto tray switching feature may
cause the paper to be fed incorrectly.
In this case, we recommend that the settings be changed as follows. For the 1st
paper drawer, change the paper type using the “TRAY1 PAPER” function on the
“PAPER SOURCE SETUP” menu of the Utility mode (p. 7-19). For the Multiple
Bypass, specify the paper type after loading the paper (p. 5-16).
To Next Page
Loading...
