Minolta Di1611 - To Copy Using the Multiple Bypass

5.4 Making Copies on Manually Fed Paper
5
Di1611/Di2011 5-19
Before Making Copies Chapter 5
To copy using the Multiple Bypass
1 Load the document to be copied.
❍ Refer to “Loading the Document” on page 3-9.
2 Adjust the Bypass Tray Extender and
the paper guides to fit the size of the
paper.
3 Load the paper with the front side
facing down, lightly sliding the paper
as much as possible into the feed slot.
The manual bypass mark ( )
appears in the bottom line of the
screen.
?
Are sheets of cards or postcards
loaded?
➜ Make sure that they are not curled
(rolled).
4 Check that “YES/NO” appears in the
bottom line of the screen, and then
press the [No] key.
The “PAPER SOURCE SETUP”
menu appears.
✎
Note
“YES/NO” is displayed for approximately 5 seconds after paper is loaded
into the Multiple Bypass.
5 Use the and keys to select
the type of paper loaded.
❍ Select from the following four
paper type settings.
“PLAIN”
“OHP”
“CARD”
“ENVELOPE”