7.5 Specifying Administrative Settings (“ADMIN. MANAGEMENT” Menu)
7
Di1611/Di2011 7-27
Utility Mode – Copy Functions Chapter 7
To select the “ADMIN. MANAGEMENT” menu
1 Press the [Utility] key.
“MACHINE SETTING?” appears.
2 Press the key 3 times to select
“ADMIN. MANAGEMENT?”.
3 From the 10-Key Pad, press the key ([1] through [2]) for the “ADMIN.
MANAGEMENT” function that you wish to set.
❍ The “ADMIN. MANAGEMENT” functions are as follows:
1 AUTO SHUT OFF
2 COPY TRACK
4 Using the 10-Key Pad, enter the 6-
digit administrator access number,
and then press the [Yes] key.
❍ To correct the administrator
access number, press the [No]
key, and then enter the new
number.
✎
Tip
If, at any time, you wish to quit setting an “ADMIN. MANAGEMENT” function,
press the [No] key. When the message “STOP SETTING?” appears, press the
[Yes] key to quit.
To Next Page
Loading...
