7
7.6 Specifying Copy Settings
7-46 Di1611/Di2011
Utility Mode – Copy Functions Chapter 7
To specify the binding width (“MARGIN SETTING” function)
1 Select the “COPY SETTING 1” menu.
❍ Refer to “To select the “COPY
SETTING 1” menu” on page 7-40.
2 Press the [6] key from the 10-Key Pad
to select “MARGIN SETTING”.
3 Using the 10-Key Pad, enter the
binding width (margin), and then press
the [Yes] key.
❍ The binding width can be set
between 0 mm and 20 mm.
❍ If you wish to correct the setting,
press the [No] key, and then enter the new number.
The “COPY SETTING 1” menu appears again.
To Next Page
Loading...
