Minolta Di1611 - To Make Copies Using the X;Y Zoom Function

5
5.7 Specifying a Zoom Setting
5-34 Di1611/Di2011
Before Making Copies Chapter 5
To make copies using the “X/Y Zoom” function
1 Load the document to be copied.
❍ Refer to “Loading the Document” on page 3-9.
2 Press the [X/Y Zoom] key until the “X/
Y Zoom” indicator lights up.
3 Using the and keys, select the desired zoom ratio for the length (X), and
then press the [Yes] key.
❍ The zoom ratio increases and decreases in 0.01 increments.
❍ Press the [Zoom] key, and then select the desired zoom ratio. Each press of
the [Zoom] key changes the zoom ratio as shown below.
× 0.50 → × 0.70 → × 0.81 → × 1.00 → × 0.50 . . .
✎
Tip
Press the [No] key to return to the main screen. To correct the specified
zoom ratio, press the [No] key, and then perform the operation again from
step 2.
Width (Y)
Length
(X)