Minolta Di1611 - Access Numbers; To Enter an Access Number

6.8 Access Numbers
6
Di1611/Di2011 6-23
Advanced Copy Operations Chapter 6
6.8 Access Numbers
If access number have been specified, use of the machine can be limited to a
specific user and the number of copies for each user can be controlled. As an
example, the following procedure describes how to enter the access number in
order to make copies.
✎
Note
If access numbers have been specified, the machine cannot be used unless the
access number is entered first.
In order to use this function, the access numbers must be specified with the
“COPY TRACK” function from the “ADMIN. MANAGEMENT” menu (“To turn on/
off user (section) management” on page 7-30).
To enter an access number
1 Using the 10-Key Pad, enter the 3-
digit account (section) access
number.
❍ If you wish to correct the entered
access number, press the [No]
key, and then enter the correct
number.
2 Press the [Access] key.
The Copy mode screen appears and
copying can be started.
3 Position the document(s) to be copied, and then select the desired copy
settings.
❍ Before Making Copies (p. 5-1)
❍ Advanced Copy Operations (p. 6-1)
4 Press the [Start] key.
5 When you are finished making copies, press the [Access] key.