Minolta Di1611 - Page 192

7.6 Specifying Copy Settings
7
Di1611/Di2011 7-39
Utility Mode – Copy Functions Chapter 7
“COPY SETTING 2” menu:
No. COPY SETTING 2 Description
1 MIXED ORIGINAL This function can be used to set whether or not the “Mixed Orig.”
function is selected when the machine starts up or after the
Control Panel is reset.
This function can be set if an optional Document Feeder is
installed.
• The manufacturer’s default setting is “OFF”.
2 COPY PRIORITY This function can be used to set whether the automatic paper or
automatic zoom ratio setting is selected when the machine
starts up or after the Control Panel is reset.
• The manufacturer’s default setting is “AP” (auto paper
selection).
3 OUTPUT PRIORITY This function can be used to specify if the selected Finishing
mode is “NON”, “SORT” or “GROUP” when the machine is
turned off or the [Panel Reset] key is pressed.
This function can be set if an optional Document Feeder is
installed.
• The manufacturer’s default setting is “NON”.
4 4IN1 COPY ORDER This function can be used to select from the following for the
page order when the 4in1 Copy mode is selected.
“PATTERN1”“PATTERN2”
This function can be set if an optional Document Feeder is
installed.
• The manufacturer’s default setting is “PATTERN1”.
5 CRISSCROSS MODE This function can be used to set whether or not copies are fed
out in a crisscross pattern when the crisscross output conditions
are met.
This function can be set if an optional Document Feeder and
Job Shifter are installed.
• The manufacturer’s default setting is “ON”.
6 DUPLEX COPY This function is used to select whether or not double-sided
printing is used.
The optional Duplex Unit must be installed. (Option only for the
Di2011)
• The manufacturer’s default setting is “OFF”.
12
34
13
24