8.4 Main Error Messages and Their Remedies
8
Di1611/Di2011 8-19
Error Messages Chapter 8
SET ORIGINAL TO ADF A document was not loaded into
the Document Feeder before
beginning a copy function (such
as, “2in1” copying or “Mixed Orig.”
copying) that uses the Document
Feeder. Otherwise, the Document
Feeder is lifted up.
Load a document into the Document
Feeder.
Securely close the Document
Feeder.
REMOVE PAPER When interrupting a copy job to
perform a different copy operation
other than the “Book Separation”
function, the document for the
interrupted copy job was left in the
Document Feeder.
Remove the document from the
Document Feeder.
TEXT/P
×1.00
ä[A]ü#XXX:EMPTY
(While specifying Copy settings)
The selected paper tray has run
out of paper.
“#” indicates the paper tray, and
“XXX” indicates the paper size.
Either load paper of the specified
size into the specified paper tray, or
press the [Paper] key and select a
different paper size.
NO SUITABLE PAPER • While copying, the size of the
paper in the selected paper tray
has changed.
• While copying documents with
mixed sizes using the Auto
Paper function, paper of a
suitable size could not be
found.
“#” indicates the paper tray, and
“XXX” indicates the paper size.
Either load paper of the specified
size, or press the [Paper] key and
select a different paper size.
(Flashing alternately)
LOAD PAPER (#XXX)
APS SIZE ERROR While copying using the Auto
Paper function, paper of a suitable
size could not be found.
Either load paper of a suitable size,
or press the [Paper] key and select a
different paper size.
AMS SIZE ERROR While copying using the Auto Size
function, the combination of the
document and paper sizes caused
the zoom ratio to exceed the range
between
×0.5 and ×2.0.
Either load paper of a suitable size,
or use the and keys to
specify the zoom ratio.
PAPER SIZE ERROR The paper loaded in the paper tray
caused a size error.
“#” indicates the paper tray, and
“XXX” indicates the paper size.
• For a Paper Feed Unit, remove
the loaded paper, and then reload
the paper according to the
procedure described in “Loading
Paper” on page 3-4.
• For a custom paper size, refer to
“To copy onto label sheets” on
page 4-8.
• For the Manual Bypass, remove
the loaded paper, and then refer
to “To copy onto label sheets” on
page 4-8. For the Manual
Bypass, remove the loaded
paper, and then reload the paper
according to the procedure
described in “Copying Onto
Manually Fed Paper” on
page 5-16.
• For a custom paper size, refer to
“To copy onto postcards” on
page 4-14.
(Flashing alternately)
RESET PAPER (#XXX)
Message Cause Remedy
To Next Page
Loading...
