MIR MiR250 HooK - Connecting the battery

4. Unboxing
MiR250 Hook Integrator Manual (en) 12/2023 - v.3.0 ©Copyright 2021–2023: Mobile Industrial Robots A/S. 49
6 Remove the last wall of the box.
7 Place the lid of the box with the reinforcement face down so that you can use it as a
ramp. Align the lid so that it is flush with the base of the box.
8 Turn on the robot and drive the robot off the ramp using manual control—see
"Powering up the robot" on page52 and "Operating the robot" on page86.
4.3 Connecting the battery
To connect the battery to the robot, you need to open the rear compartment—see "Accessing the
internal parts" on page149.