13. Error handling
MiR250 Hook Integrator Manual (en) 12/2023 - v.3.0 ©Copyright 2021–2023: Mobile Industrial Robots A/S. 175
l
Sign in to the robot interface and go to Monitoring >Hardware health. The interface displays
which component is failing and often for what reason. This can help identify the source of the
error. If an internal component is failing, turn off the robot, disconnect the battery, and have
the commissioner or operator visually check the internal component for obvious faults.
l
For further troubleshooting, see the MiR troubleshooting guides and the document Error codes
and solutions. You can find these guides on MiR Support Portal.
13.3 Error codes and solutions
Use the MiRtroubleshooting guide to resolve many of the errors the robot reports. You can find
these guides on MiR Support Portal.
Code Type Solution
1001 Hardware error. The safety system has detected a fault in
Table 13.1 Common error codes the robot reports
To Next Page
Loading...
