MIR MiR250 HooK - Connecting the robot to a Wi-Fi network

4. Unboxing
MiR250 Hook Integrator Manual (en) 12/2023 - v.3.0 ©Copyright 2021–2023: Mobile Industrial Robots A/S. 57
5 In a browser, go to the address 192.168.12.20 and sign in.
4.7 Connecting the robot to a Wi-Fi network
To communicate with the robot wirelessly without using an access point, connect the robot to
your localWi-Fi network. This enables you to access the robot interface via your Wi-Fi network by
entering the assigned IPaddress of your robot in a web browser.
To connect the robot to a Wi-Fi network, follow these steps:
1 Connect to your robot as described in "Connecting to the robot interface" on page55.
To comply with the robot's certification, you must use an Ethernet cable to avoid
simultaneously active radio transmitters while setting up the connection to the local
Wi-Fi network.