MIR MiR250 HooK - Packing the robot for transportation

14. Transportation
MiR250 Hook Integrator Manual (en) 12/2023 - v.3.0 ©Copyright 2021–2023: Mobile Industrial Robots A/S. 183
14.2 Packing the robot for transportation
Before packing the robot for transportation:
l
Place the hook arm in a 22° angle—see "Operating the robot" on page86.
l
Shut down the robot—see "Shutting down the robot" on page54.
l
Disconnect the battery—see "Disconnecting the battery" on page82.
l
Place the foam blocks exactly as they were before unpacking the robot—see "Unpacking
MiR250 Hook" on page46
Use the original packaging materials when transporting the robot.
Figure 14.1 The packing materials
The packaging materials are:
l
The bottom of the box (the pallet)
l
The lid of the box (the ramp)