103
Operation
4. When finished the page, release the PTT button on the microphone.
Any pre-selected zone LEDs will signal steady and those zones will remain available for
further paging. Press Clear Selection to clear all active zone indicators.
If an All Call was made, all zones and zone LEDs will reset when the PTT button is
released.
To page the audio system with the QX-mini-RM
1. Unhook the microphone from its housing, and then press the Push-To-Talk (PTT) button
on the microphone.
If the System in Use LED flashes yellow, another microphone with a higher priority has
control of the audio channel. The system will not page when another operator’s
microphone has control. The QX-mini master microphone has highest priority.
2. When the Ready To Page LED lights green, begin the page.
3. When finished the page, release the PTT button on the microphone.
Page Inhibited on the QX-mini or QX-mini-LOC
1. During a page or prior to beginning a page, the FACP triggers an alarm or fire drill. On
the FACP, alarm visual indicators will illuminate and any assigned alarm message will
play.
The assigned LED for the Page Inhibited will flash yellow at trouble rate, indicating why
paging will not function.
Note: During the Page Inhibited, the PTT will not activate a page until the user-set period
of time expires.
2. Wait until the Page Inhibited LED is extinguished (even if alarm is active) then press PTT
button, pre-tone will play, and paging ability resumes.
Note: Alarm may continue after page is complete depending on configurator alarm
duration settings.
Page Inhibited on the QX-mini-RM
1. During a page or prior to beginning a page, the FACP triggers an alarm or fire drill. On
the FACP, alarm visual indicators will illuminate and any assigned alarm message will
play.
The System In Use LED for the Page Inhibited will flash yellow at trouble rate, indicating
why paging will not function.
Note: During the Page Inhibited, the PTT will not activate a page until the user-set period
of time expires.
2. Wait until the System In Use LED is extinguished (even if alarm is active) then press PTT
button, pre-tone will play, and paging ability resumes.
Note: Alarm may continue after page is complete depending on configurator alarm
duration settings.
To Next Page
Loading...
Need help?
General
