Mitsubishi Electric MELSEC iQ-F Series - Refresh settings

7 PARAMETER SETTINGS
7.3 Basic Settings
133
7
Refresh settings
Assign link refresh ranges between the following devices.
• SB, SW, link devices (RX, RY, RWr, RWw) of the FX5-CCLGN-MS  Devices of the FX5 CPU module
Setting method
The procedure for the refresh settings is as follows.
1. Set the required items.
2. Click the [Apply] button to finish "Refresh Settings".
Setting items
The setting items for the refresh settings are as follows.
Item Description Setting range
For master stations For local stations
Device Assignment
Method
Right-click in the setting window and select a link device assignment method
from the "Device Assignment Method" menu.
• Start/End: Enter the start and end numbers of link devices.
• Points/Start: Enter the numbers of points and start numbers of link devices.
•Start/End
• Points/Start
(Default: Start/End)
 Link Side Set the link refresh ranges of SB and SW. One link refresh range can be set
for each of SB and SW. ( Page 32 Link refresh)
Device Name
•SB (fixed)
•SW (fixed)
Points
• SB: 16 to 4096 (set in increments of 16 points)
• SW: 1 to 4096
(Default: empty)
Start
• SB: 0H to FF0H (set in increments of 16 points)
• SW: 0H to FFFH (set in increments of 1 point)
(Default: empty)
End
• SB: FH to FFFH (set in increments of 16 points)
• SW: 0H to FFFH (set in increments of 1 point)
(Default: empty)
CPU Side Ta rge t
• Specify Device
(Default: empty)
Device name
• Specify Device (link side is SB): SB, M, L, B, D,
R
• Specify Device (link side is SW): SW, M, L, B, D,
R
(Default: empty)
Points, End
Displayed according to setting of "Start".
(Default: empty)
Start
Device range of FX5 CPU modules (Set bit
devices in increments of 16 points and word
devices in increments of 4 points.)
(Default: empty)
FX5-CCLGN-MS
00000H
001FFH
00000H
001FFH
00000H
·
·
·
·
001FFH
00000H
001FFH
Device name
(SB)
FX5 CPU module
Device name
(SW)
Device name
(SB)
Device name
(SW)
Ex.