Mitsubishi Electric MELSEC iQ-F Series - Module Operation Mode; Security

7 PARAMETER SETTINGS
7.4 Application Settings
139
7
Module Operation Mode
Set the mode for the FX5-CCLGN-MS.
For details on the module communication test mode, refer to the following.
Page 200 Module communication test
The following functions are disabled when "Module Operation Mode" is set to "Offline" or "Module
Communication Test". ( Page 22 FUNCTIONS)
• Cyclic transmission
• Transient transmission
•RAS
• Interrupt request to CPU module
In line topology, data link is not performed for stations connected after a station in offline mode.
Security
Set the security measures for access to the Ethernet device.
IP Filter Settings
Up to 32 IP addresses can be set as an IP address to be allowed or denied by the IP filter.
Range specification as a single setting and specification of the IP addresses to be excluded from the set range are also
possible.
Item Description Setting range
Module Operation Mode Online
• Select this mode to connect the FX5-CCLGN-MS to the network for performing data
link with other stations.
Offline
• Select this mode to disconnect the FX5-CCLGN-MS from the network and not perform
data link with other stations.
Module Communication Test
• Select this mode to check the hardware of the FX5-CCLGN-MS. Select this mode to
check the module hardware when communications are unstable.
• Online
• Offline
• Module Communication Test
(Default: Online)
Item Description Setting range
IP Filter
Settings
IP Filter Set whether to use the IP filter. • Do Not Use
•Use
(Default: Do Not Use)
IP Filter Settings Set the IP addresses to be allowed or denied. 
Item Description Setting range
Access from IP address below Select whether to allow or deny the access from the specified IP addresses. • Allow
• Deny
(Default: Allow)
Range Setting Select this item when specifying the IP addresses by range. (Default: Clear)
IP Address Set the IP addresses to be allowed or denied.
When selecting "Range Setting", enter the start IP address (left field) and end IP
address (right field) of the range.
0.0.0.1 to 223.255.255.254
(Default: empty)
IP Address Excluded from Range When selecting "Range Setting", set the IP address to be excluded from the set
range.
Up to 32 IP addresses can be set.
0.0.0.1 to 223.255.255.254
(Default: empty)