8 DEDICATED INSTRUCTION
151
8
8 DEDICATED INSTRUCTION
This chapter describes the transmission ranges and dedicated instructions that can be used in the FX5-CCLGN-MS.
For details on dedicated instructions, refer to the following.
MELSEC iQ-F FX5 Programming Manual (Instructions, Standard Functions/Function Blocks)
Link dedicated instructions
The following table lists the instructions used for transient transmission to or from programmable controllers on other stations.
■Instruction list
■Transient transmission ranges
In a single network system, communication with all stations on the network is possible.
SLMP communication instruction
The following table lists the dedicated instruction used to send an SLMP frame to an SLMP-compatible device in the same
network.
■Instruction list
Other dedicated instructions
Set the parameter in the FX5-CCLGN-MS.
■Instruction list
Instruction Description
GP.READ Reads the data from devices in the programmable controller of another station.
GP.SREAD Reads the data from devices in the programmable controller of another station. For the GP.SREAD instruction,
when the reading of the data is completed, another station's devices are turned on. Other stations can
recognize that the data was read by GP.SREAD.
GP.WRITE Writes the data to devices in the programmable controller of another station.
GP.SWRITE Writes the data to devices in the programmable controller of another station. For the GP.SWRITE instruction,
when the writing of the data is completed, another station's devices are turned on. Other stations can
recognize that the data was written by GP.SWRITE.
GP.SEND Sends data to the programmable controller of another station.
GP.RECV Reads the data received from the programmable controller of another station.
Instruction Description
G(P).SLMPSND Sends an SLMP message to the SLMP-compatible device in the same network.
Instruction Description
G(P).UINI Sets the station number and IP address in the FX5-CCLGN-MS.
To Next Page
Loading...
