Mitsubishi Electric MELSEC iQ-F Series - Structure of CC-Link IE TSN Class B Devices and Ethernet Devices

64
5 SYSTEM CONFIGURATION
5 SYSTEM CONFIGURATION
CC-Link IE TSN is configured using Ethernet cables. ( Page 128 Ethernet cable)
System configuration list
The following table shows the system configuration list.
The firmware version can be found in the of the following locations.
• The module diagnostics (CPU diagnostics) window of the engineering tool
• 'MIB information firmware version' (Un\G41) ( Page 255 MIB information firmware version (Un\G41))
For details on MIB information, refer to the following.
Page 249 Buffer Memory
Precautions
To connect modules on CC-Link IE TSN, a dedicated industrial switch (for CC-Link IE TSN Class B) may be required
depending on parameter settings or the network topology used.
(1) FX5-CCLGN-MS
(2) Inverter device
(3) Remote I/O module
(4) Ethernet device (such as a vision sensor)
Configuration Firmware version of the
master station
CC-Link IE TSN Protocol
version of CC-Link IE TSN-
compatible device
Reference
Structure of CC-Link IE TSN Class B
devices and Ethernet devices
Page 66 Structure of CC-Link IE TSN
Class B Devices and Ethernet
Devices
Structure of CC-Link IE TSN Class B/
A devices and Ethernet devices
"1.010" or later 2.0 only Page 76 Structure of CC-Link IE TSN
Class B/A Devices (CC-Link IE TSN
Protocol Version 2.0 Only) and
Ethernet Devices
Mixture of 1.0 and 2.0 Page 92 Structure of CC-Link IE TSN
Class B/A Devices (Mixture of CC-
Link IE TSN Protocol Version 1.0 and
2.0) and Ethernet Devices
"1.002" or earlier 1.0 only Page 97 Structure of CC-Link IE TSN
Class B/A Devices (CC-Link IE TSN
Protocol Version 1.0 Only) and
Ethernet Devices
(4) (1)
(3) (2)