9 PROGRAMMING
9.2 Communication Example Between the Master Station and Local Station
161
9
4. Set the items in "Required Settings" as follows.
[Navigation window] [Parameter] [Module Information] [FX5-CCLGN-MS] [Required Settings]
• For station No.1
• For station No.2
5. Set the refresh settings as follows. Set the local stations with station No.1 and station No.2 to the same refresh settings.
[Navigation window] [Parameter] [Module Information] [FX5-CCLGN-MS] [Basic Settings] [Refresh
Settings]
6. Click the [Apply] button.
7. Write the set parameters to the FX5 CPU module on the local station. Then, reset the FX5 CPU module or power off and
on the system.
[Online] [Write to PLC]
In this example, default values are used for parameters that are not shown above. For the parameters, refer to
the following.
Page 129 PARAMETER SETTINGS
To Next Page
Loading...
