Mitsubishi Electric MELSEC iQ-F Series - Page 266

264
APPX
Appendix 3 Buffer Memory
Own node setting status storage area
Own node IP address (Un\G52228 to Un\G52229)
The setting values of the IP address are stored.
Range: 1H to DFFFFFFEH
Subnet mask (Un\G52238 to Un\G52239)
The setting values of the subnet mask are stored.
Range: 1H to FFFFFFFFH
0: No setting
Default gateway IP address (Un\G52242 to Un\G52243)
The setting values of the default gateway are stored.
Range: 1H to DFFFFFFEH
0: No setting
Own node MAC address (Un\G52252 to Un\G52254)
The own node MAC addresses are stored.
• Un\G52252: 5th byte, 6th byte of the MAC address
• Un\G52253: 3rd byte, 4th byte of the MAC address
• Un\G52254: 1st byte, 2nd byte of the MAC address
Own node network number (Un\G52255)
The setting value of the network number is stored.
Range: 1 to 239
0: Network number not set
Station number (Un\G52256)
The setting value of the station number is stored.
Range: 1 to 120
0: Station number not set
125: Master station
Transient transmission group No. (Un\G52257)
The setting value of the transient transmission group number is stored.
Range: 1 to 32
0: No group specification
Auto-open UDP port port number (Un\G52261)
The port number used for the auto-open UDP port is stored.
MELSOFT transmission port (TCP/IP) port number (Un\G52262)
The port number used for the MELSOFT transmission port (TCP/IP) is stored.
MELSOFT transmission port (UDP/IP) port number (Un\G52263)
The port number for the MELSOFT transmission port (UDP/IP) is stored.
SLMP transmission port (TCP/IP) port number (Un\G52265)
The port number used for the SLMP transmission port (TCP/IP) is stored.
SLMP transmission port (UDP/IP) port number (Un\G52266)
The port number used for the SLMP transmission port (UDP/IP) is stored.